Position: Home page » Pool » Water consumption of ore washing machine

Water consumption of ore washing machine

Publish: 2021-03-22 04:27:05
1. Dig three or more pits on the side of the ore washing machine. The posture is arbitrary. As long as the three or more pits are connected together, the injected water will become infinite water. Then put the instrial pump next to the ore washing machine and power on. OK, the instrial pump will pump the water from the pit just g into the ore washing machine!
2.

In the instrial "beating and washing process"

  1. pulverizing, one ore is put into the pulverizer, which consumes EU and time, and turns into two crushed ores, increasing proction by two times as much as the original one, Some small pieces of powder (9 small pieces of powder, a powder, a furnace to burn powder into an ingot), and a stone powder (which can be used as building foam)

  2. centrifugation, and put 1 pure crushed ores into the heat centrifuge (must give the centrifuge red stone signal, or it will consume a lot of time). It still consumes EU and time, and becomes a powder, a handful of powder (except uranium mine). It will become uranium 238 and 235)

  3. @ ztw0_ 0

3.

1、 Steps:

1, the use of the pump needs to dig a pool out first, and put water on it


4. Ore washing machine: further increase mineral proction (increase by 44.4%), obtain stone powder and Xiaocuo sulfur powder
centrifuge: centrifuge copper powder to get small piles of gold powder and nickel powder; The ruby powder and mercury unit were obtained by centrifuging the ruby; Helium unit and rutile were obtained by centrifuging fluorite, nickel and copper were obtained by centrifuging gold powder
the difference between the two:
1. The latter consumes more electric ore washing machine. In short, it uses water to clean the crushed ore to proce pure powder (Elemental) and impurities (also elemental minerals)
2. The former needs water to proce pure ore powder and impurities
my world instry is an open game, which can use very simple materials to make many strange modern works, such as using the most natural rubber to make batteries and other instries.
5. Well. I can't use it either. Everything I put is the same as 172, but it doesn't work.
6. BC ct mod, if not, it will be put in buckets one by one.
7. Because it's near thiazole
8. Put the pump in the water and power on. Pay attention to the direction. The pump can only pump water from the front. Don't block the front
9.

Haier washing machine washing machine distribution box water leakage is caused by excessive water pressure, water spills, washing machine foam too much from the washing powder box overflow. p>

Haier drum washing machine detergent distribution box leakage solution: use low bubble or no bubble washing liquid, also can put less washing liquid

the water leakage of washing machine is generally divided into drainage pipe leakage and washing machine bottom leakage. If there is water leakage of washing machine, it needs to be checked one by one according to the above situation. If the bottom of the washing machine leaks, you need to open the plastic cover in the lower right corner of the front of the washing machine to check whether the knob inside is loose

check the washing powder cylinder and washing machine door for water leakage. If there is water leakage in this area, it is usually caused by too much washing powder. At this point, it is recommended that users use low foam detergent or put less detergent, so as to avoid washing machine

for example, Haier washing machine has the function of intelligently identifying how much washing liquid is put in the clothes, which can maximally prevent the washing machine leakage caused by too much washing liquid

{rrrrrrr}

extended data:

other reasons for water leakage of Haier drum washer are as follows:

1. The drainage valve is too elastic or the drainage rope is too short, and the drainage rubber ring can not be put down, resulting in loose connection around the drainage outlet and a gap, so the elastic drainage valve and Drainage Belt should be adjusted appropriately, And drains should be re installed

It is necessary to replace the drain pipe with a new one

3. The drainage rubber ring is aging and cracking or losing elasticity, which leads to poor sealing function and water leakage. Make sure that it is necessary to replace the drain rubber ring

4. Leakage ring dehydration. The reasons may include: the rubber sleeve of the sealing ring in the wave wheel of the dewatering shaft is damaged or not strictly sealed, the rubber sleeve of the wave wheel itself has cracks or aging, the dehydration adhesion between the rubber sleeve of the wave wheel and the bucket outlet is not tight, or the use of degumming and water leakage are formed

10. The washing equipment depends on how you wash the ore. if you wash the ore, the raw materials should not be too large. You can directly use a spiral washing machine or a high-frequency screen, vibrating stone washing machine, spiral chute, shaker, etc. different raw materials have different washing methods. When washing the ore, you should choose the equipment according to the output
Hot content
Inn digger Publish: 2021-05-29 20:04:36 Views: 341
Purchase of virtual currency in trust contract dispute Publish: 2021-05-29 20:04:33 Views: 942
Blockchain trust machine Publish: 2021-05-29 20:04:26 Views: 720
Brief introduction of ant mine Publish: 2021-05-29 20:04:25 Views: 848
Will digital currency open in November Publish: 2021-05-29 19:56:16 Views: 861
Global digital currency asset exchange Publish: 2021-05-29 19:54:29 Views: 603
Mining chip machine S11 Publish: 2021-05-29 19:54:26 Views: 945
Ethereum algorithm Sha3 Publish: 2021-05-29 19:52:40 Views: 643
Talking about blockchain is not reliable Publish: 2021-05-29 19:52:26 Views: 754
Mining machine node query Publish: 2021-05-29 19:36:37 Views: 750