MCBC miner does not work

In the instrial "beating and washing process"

1. pulverizing, one ore is put into the pulverizer, which consumes EU and time, and turns into two crushed ores, increasing proction by two times as much as the original one, Some small pieces of powder (9 small pieces of powder, a powder, a furnace to burn powder into an ingot), and a stone powder (which can be used as building foam)

2. centrifugation, and put 1 pure crushed ores into the heat centrifuge (must give the centrifuge red stone signal, or it will consume a lot of time). It still consumes EU and time, and becomes a powder, a handful of powder (except uranium mine). It will become uranium 238 and 235)

3. @ ztw0_ 0
   

1. First of all, use stones or other blocks to place them as shown in the figure

Other tools needed for the use of mining machine: Mining bit, OV or od scanner

1. After preparing the above tools, power on the mining machine

2. Put the drill bit, mining pipe and OD scanner into the position of the mining machine interface as shown in the figure below. When the power supply of the mining machine is enough, mining will begin

note: before the scanner, set the blacklist (that is, you don't want to collect) or white list (ore must be put in it), and then select accurate collection or inaccurate collection

extended data

mining machine is a kind of automatic vertical mining machine. Placing a box beside you can automatically put the collected items into the box. The power consumption of mining opportunities varies according to the internal components (one-time excavation) - mining bits: 450eu ~ 470eu

diamond bit: 880eu ~ 900eu; Od detector: 45eu ~ 75eu; OV detector: 165eu ~ 190eu. The maximum input voltage is 32eu / T, which will explode. The components in the mining machine include: drill, scanner and mining pipe. The number of pipes will be greater than or equal to 1. None of the three components will work without one