Position: Home page » Pool » What light does the A6 miner AUC light normally

What light does the A6 miner AUC light normally

Publish: 2021-05-21 20:29:24
1. Maybe the brake pads overheated and expanded! Touch the ABS sensor! No problem! However, it is suggested to go to the maintenance station to check if there are other faults
2. Hello
if the fault light is always on after the vehicle is started, it means that the engine electronic control system has failed
the common cause may be the fault of
engine sensor, or the damage of
actuator, or the line
you need to go to the repair shop and read the specific fault code with the decoder. Generally, when it is on, the power of the vehicle will drop and the fuel will be wasted
it is recommended that you repair it as soon as possible! I hope I can help you. Have a good time Automobile questions, ask
automobile master
. 4S shop professional technician, 10 minutes to solve
3. There is something wrong with the electronic steering system. There is a power steering motor and a steering sensor under the steering wheel. There is an EPS computer in the middle under the instrument panel. Maybe something is wrong, or there is something wrong with the relevant insurance or the circuit. It is recommended to use a special computer for testing
4. Hello, according to your picture. On the left is the electronic throttle. It is also called engine power rection indicator. On the right are the airbag warning lights. Parking brake indicator and battery charging system fault indicator, I hope my answer can help you.
5. You go to the repair shop to have a look... The oil light is on... Generally, the oil pressure is not enough
6. The reasons for the fault light of Audi A6L engine are as follows:
1. Poor gasoline quality will lead to insufficient combustion of the mixture in the cylinder, which will cause the fault light to turn on, and it is easy to proce carbon deposition
2. The existence of carbon deposition on the top of the piston in the intake port will lead to poor atomization, resulting in insufficient combustion and the fault light on
3. When the cold car starts, especially when the weather temperature drops sharply, the fault light will be on because of the temperature correction problem of the computer, but it will be relatively stable as long as the temperature drops to a certain level and does not fluctuate
4. If the engine mileage is too long and the working characteristics of spark plug are weakened, the fault light will be on.
7. You can check whether modem is in normal state according to the indication of modem status light. 1. Power light: it is usually labeled as "power" or "PWR" on the modem. Normally, it should be green and on for a long time. When the light is not on, please check whether the modem power is plugged in or the power switch is turned on. Otherwise, the modem may be out of order. It is recommended to call No. 10000 to report the failure. 2. Synchronization lamp: it is generally labeled as "DSL", "ADSL", "status" or "link" in modem. Long on indicates synchronization, flashing indicates detection of synchronization signal, and off indicates no synchronization; If it can't be synchronized, please check whether the telephone line connected to modem is loose. In addition, the indoor installation of telephone equipment should pay attention to the wiring method. 3. Computer connection light: it is usually labeled as "Lan", "PC", "Ethernet" in modem, and normally it is on for a long time. When it is not on, please check whether there is a prompt "local cable has been pulled out" in the lower right corner of the computer screen. If so, dial and plug in the network cable. Otherwise, please check whether the network card status is normal. If the network card driver under "network card" or "network adapter" has a red cross, the network card will be disabled. You can click the right mouse button to enable the network card; However, if there is a question mark or exclamation mark in the network card driver in the device manager, or "local connection" or "network adapter" cannot be found at all, it may be a problem with the network card driver, network card or motherboard. Customer service 48 will answer for you. The broadband service is fast, and the China Telecom official account of Guizhou customer service reply to the key words "broadband on demand" can be handled directly and conveniently.
8. Hello
engine oil lamp alarm caused by insufficient oil pressure
I suggest you
check it early
you can't deal with it any more
if the oil pressure is not enough
the engine's own working efficiency is not perfect
9. It's probably an automatic light
Hot content
Inn digger Publish: 2021-05-29 20:04:36 Views: 341
Purchase of virtual currency in trust contract dispute Publish: 2021-05-29 20:04:33 Views: 942
Blockchain trust machine Publish: 2021-05-29 20:04:26 Views: 720
Brief introduction of ant mine Publish: 2021-05-29 20:04:25 Views: 848
Will digital currency open in November Publish: 2021-05-29 19:56:16 Views: 861
Global digital currency asset exchange Publish: 2021-05-29 19:54:29 Views: 603
Mining chip machine S11 Publish: 2021-05-29 19:54:26 Views: 945
Ethereum algorithm Sha3 Publish: 2021-05-29 19:52:40 Views: 643
Talking about blockchain is not reliable Publish: 2021-05-29 19:52:26 Views: 754
Mining machine node query Publish: 2021-05-29 19:36:37 Views: 750