My world rail miner
1. First of all, use stones or other blocks to place them as shown in the figure
and then from top to bottom (the arrow represents the funnel orientation)
box (burning procts)
funnel ﹣ box (fuel)
furnace ﹣ funnel
funnel ﹣ box (finished procts)
the lower two spaces can be changed to
leaky bucket → box
or
box ﹣ funnel
to save space
the box can be changed to Replace it with a wooden bucket, and the latent shadow box
box can also be combined with the need to synthesize a large box
1. The most common rail - rail
there is no power, and only by pressing and holding the forward key on the tramcar can it move forward slowly. And affected by the terrain, it will accelerate when encountering downhill, decelerate or even stop and slide backward when encountering uphill. It is also the only one of the four types of tracks that can turn
2
in normal state, it is black or dark red, which has deceleration effect, and the tramcar will stop or decelerate when passing by. Activated by the red stone signal, it appears red. It has the function of acceleration. The tramcar will speed up when passing by
3. The track that activates the red stone signal is the detection track
if there is a tramcar passing by, it will send out a red stone signal, and the detection track will turn red. Note: the track that activates the red stone signal is not called the activated track
4
it was dark red in normal state, and bright red when red stone signal was activated. When people or animals sit on the tramcar and pass the activated rail, the tramcar will shake left and right, and people or animals will leave the tramcar. The activated track will not have any effect after the red stone signal is not activated
the method of placing the rail is as follows:
1. Take out the rail, as shown in the figure below
1. The tramcar has been moving in the same direction as the tramcar
2. When the tramcar stops but one end of the tramcar is close to a solid block, the direction of starting and accelerating of the tramcar is opposite to that of the solid block
3. When the tramcar stops but the charged rail is on the ramp, once the charged rail is activated, the tramcar will start and start downward e to gravity. At this time, the acceleration direction of the rule is downward
4. The second and the third of the above rules can be used to make a very simple button triggered departure device, which can not only make the incoming cars stop safely for the convenience of getting on and off or goods exchange, but also simply press the button to send out the tramcar