1060 superfrequency Ethereum
rx570 / 580 level display,
if it's a gtx1060
3G, it's an ordinary graphics card overclocking, and the core overclocking increases by 20%, Video memory overclocking increased by 10% on the line.
don't overclock the video memory too much. It has no radiator cover. Overclocking is not a problem at that time. Later, it will be aging quickly. The video card will display the screen early. There is no way to repair the aging fault caused by overclocking.
as for the excess, you can increase it by 5% first and then slowly, depending on the constitution of your video card
At present, there is not much overclocking range for the graphics card. Moreover, the overclocking of the graphics card is greatly affected by the chip constitution, the rated power of the power supply, and the number of phases of the power supply of the graphics card. Generally speaking, for a gtx1060 overclocking, the general constitution does not pressurize the overclocking, and the core overclocking increases by 15%, a few can increase the overclocking by 20%, and the video memory overclocking increases by 10%
the video memory should not be overcrowded too much. It has no radiator cover. There is no problem when overcrowding occurs, but it will age quickly later. The graphics card will display the screen early. There is no way to repair the aging fault caused by overcrowding
Overclocking itself has a loss on the graphics card, so you don't need to overclock when you play enough games. When you feel that the performance is poor when you play large games, you can overclock the core frequency of the graphics card to improve the performance, but don't overdo it too much. In the case of the original frequency, it's better to exceed 5% to 8%. For example, if the core frequency is 1000, you can surpass 1100 and 1150
Enter
the first one is one of the unique functions of ACC, sb710, sb750 South Bridge, which is also the key to the development of nuclear power
first, EC firmware selection allows you to select the EC firmware for advanced clock calibration. When opening the core, you need to adjust this item to special to call the firmware for opening the core.
the second item is ACC, which is generally set to auto.
the third item, CPU core control, is to choose to close some cores, Especially for the open four core instability, you can test to see if that core is not good, turn on three core instead, or even just open L3.
OK, press ESC to exit and continue to talk about the overclocking part
item, CPU clock ratio, CPU frequency doubling selection, regardless of other first, anyway, it's not a black box, frequency doubling can only be adjusted down, only for high external frequency, Forced to turn down the frequency multiplier
it can be selected automatically, and it can be stabilized between 2000 and 2200, which is more convenient. You can also turn the frequency down. My x2245 is X10 by default, which can be adjusted down a little to achieve stability. Beiqiao has high memory performance, but relatively speaking, the success rate and security of overclocking are also low. The north bridge is super explosive. It's also a cup maker. Be careful.