The requirement of computer vision for computing power

1. RX
vega56 is compared with
gtx1080
the difference is just a little bit in the core frequency
so the performance is to locate the high-end series graphics card,
gtx1660ti
and gtx1660s are located in the middle and high-end graphics card, gtx1660ti is equivalent to
gtx1070
almost, so it is not at the same level as RX
vega56,

2. No, the performance gap is too big
RX Vega 56 is the same as gtx1070, even stronger.

3. I don't think so. It's very troublesome to park at that location. It's hard to find a parking space

4. The taxi cost is about 12 yuan (calculated according to the shortest driving time)

1
route 92
the whole journey is about 20 minutes / 811 meters

Hangzhou Jiali center
374 meters
walk to Huansha intersection station on Qingchun Road
Huansha intersection station on Qingchun Road
1 station
take route 92 (or 251), Get off at Shiyi hospital station
Shiyi hospital station
82m
walk to wufangzhai Hangzhou Huansha road franchise store
wufangzhai Hangzhou Huansha road franchise store

5. Use BIOS to adjust the fan speed (how to do this, ask Du Niang), or change the fan.

6. The reasons for the high noise in summer are as follows:
1. High temperature, low coil resistance inside the fan and high fan speed
2. High temperature! It causes the internal bearing oil to dry up, causing high noise
it is suggested to replace the fan with two ball bearings. The problem can be solved, but the unit price is higher, but the service life is longer
for fans in summer, every factory is worried about it. At present, fans used in computers have low unit prices. In order to rece costs, manufacturers use oil-bearing bearings instead of ball bearings. It would be much better if they use ball bearings. But the unit price
has gone up, so it is generally not used< The characteristic of oil-bearing is high speed in summer and low speed in winter.
so don't worry, it's normal
I am a fan developer! Your question is very simple.

7. If you buy a good fan, the speed is usually about 1000 rpm, because a good fan has a higher requirement for silence. The slower the speed is, the quieter it is. A common fan has a higher speed and a higher noise. In addition, no matter what the fan speed is, if the CPU temperature is normal, it means that there is no problem with the fan. It is recommended to run the temperature and pressure test function in Master Lu's temperature monitoring for 3-5 minutes to observe whether the CPU temperature rises normally. Generally, an alarm will be given when the temperature reaches 80 degrees. The fan or this speed is the fan problem
I hope my answer can help you

8. Clean up now! You have to clean the st and put on silica gel immediately. Or something will go wrong., The fan is not a problem. The fan is OK
st removal should be done quickly. Generally, the st removal cycle is one year
I hope I can help you.

9. This question has been asked before. To answer this question again, first of all, the boxed fans are small fans. Under the same cooling effect, the small fan must rotate at a high speed to achieve the normal cooling function. The increase of rotating speed will bring about the disadvantage of high noise, but it does not affect the use of the computer. If you really don't like it, it is recommended to replace a large fan, At the same time, it is not recommended to use software to forcibly rece the fan speed. Although the speed will come down and the noise will be reced, the heat dissipation efficiency will also be greatly reced, affecting the CPU life.

10. You put the fan down, put some vegetable oil in it, lubricate it, and make sure there is no noise.