How to calculate the column axial force when the top is a wooden

1. The axial force at the upper end of each column is obtained by adding the shear force at the end of the transverse frame beam, the reaction force at the end of the longitudinal frame beam (calculated according to the simply supported beam) and the axial force from the upper column; The axial force at the lower end of each column is the axial force at the upper end plus the self weight of the column.

2. According to the building height, the section size of beam and column, the thickness of floor and roof panel, wall material and thickness, decoration method and roof live load of factory building, the axial force of center column, side column and corner column is calculated or roughly calculated in combination with the code for design of building structure and code for seismic design of buildings. In fact, it's very fast to calculate with software
when estimating the area of foundation bottom, the factor of foundation buried depth should also be considered
for reference only. I wish you all the best.

3. The axial force at the bottom of the column is the axial force at the top of the column plus the self weight of the column itself, which is only considered when calculating the vertical dead load. When calculating the live load, the axial force at the top and bottom of the column take the same value.

4. You must give the type of material and strength grade of the column, so that I can help you judge. If it is a concrete column, simply according to the axial compression member calculation, the steps are roughly as follows: the axial force of each column is 2000 × one thousand × 10 / 27 = 740N, l0 / b = 4.75 / 0.5 = 9.5, look up the table stability coefficient φ= 98, according to the formula: n ≤ 0.9 φ( fcA+f' yA' s)=0.9 × zero point nine eight × fcA+f' yA' s) According to what you said, the process can only be written here. You must know the number and size of steel bars and the strength grade of concrete. Of course, if I design it, C30 concrete is used, FC = 19.1n/mm

5. The vertical force acts on the column directly, and its axial force is the vertical pressure. The bearing capacity (i.e. normal pressure) and the pressure stability calculation of the column should be calculated. All must meet the design requirements.

6. If your problem refers to frame column, then:
1. First, calculate the bending moment of the joint, and distribute it to the rod end (including the column end) of each member on the joint to get the bending moment of the column end
2. According to the bending moment at the end of the column, the shear force at the end of the column is assumed to be an unknown number, and the moment balance equation of the member is established to calculate the shear force at the end of the column
3. According to the sum of the shear force at the beam end from the beams on both sides of the column top and the axial force at the bottom of the upper column at the column top, it is the axial force at the upper end of the column. The axial force at the upper end of the column plus the self weight of the column is the axial force at the lower end of the column.

7. It is possible that you have violated the rules of credit card use in the process of using your credit card. For specific reasons, you can go to the local bank card center or call the unified customer service hotline of ICBC to consult the bank staff.

8. The most powerful miracle has a high degree of restoration. It is the most popular mobile game at present. Better experience, there will be a new experience.

9. Yao Yao seems to have said that there are 11 songs in this album, so there should be. Isn't everyone looking forward to the countdown?