How to calculate the cohesive force of anchor rod
if you have any questions, please ask directly
if you don't have any questions, please set me as the satisfied answer, thank you!
According to the design requirements, if there are no design requirements, the ultimate tensile force of the bolt body (reinforcement) is used for destructive testing. For the full-length adhesive bolt, that is, the full-length grouting, the cohesive force is far greater than the rod body, that is, the rod body breaking is the ultimate tensile pull-out force
When one of the following conditions occurs, the pull-up test can be terminated:1
The newly added pull-up force could not be applied or could not keep stable after being applied3. The reinforcement of the bolt has been pulled out, or the reinforcement of the bolt has been pulled out
extended data:
when the range of the test bolt participating in the statistics does not exceed 30% of the average value, the average value can be taken as the ultimate bearing capacity of the bolt. When the range exceeds 30% of the average value, the test quantity should be increased and the reasons for the large deviation should be analyzed to determine the ultimate bearing capacity in combination with the engineering situation
The characteristic value of pullout bearing capacity RT is divided by safety factor 2.when drilling, the rock core should be processed into standard specimens, and the uniaxial compression test of rock should be carried out under the condition of natural humidity. The number of samples for each test bolt should not be less than 3
after the end of the test, it is necessary to make a detailed description and take photos of the failure of the anchor test site
this is their website. You can go up and learn about it first.
I personally think that no matter which school is a learning place, the final result depends on your academic performance. There are more joint classes in Zhangjiakou Vocational Ecation Center, For students, the employment problems or opportunities for further ecation after graation are promoted.
students in any school have good and poor development after graation, and some even have no effect on three years of study. However, for a school, it is to evaluate its rate of further ecation and the grade of the school they enter. Zhangjiakou Vocational Ecation Center can also enter a university, But compared with the enrollment rate of No.1 middle school, the enrollment rate of Zhangjiakou Vocational Ecation Center may be more than 2 or 3, and less than 1. This is the general situation of a school. Such two types of schools are all like this, but there are also students who are promoted to 1, and those who are directly recruited by big companies in big cities are all top learners, Although those students didn't try their best to study well in junior high school, they may have matured a lot and become the model of learning. What about you? No matter what school you choose, I wish you can become a pacemaker!
bus line: No.11, the whole journey is about 12.2km
1. Walk about 540 meters from Zhangjiakou South Railway Station to Zhangjiakou South Railway Station
2. Take No.11, pass 22 stations, and reach the Vocational Ecation Center Station
3. Walk about 520 meters to Zhangjiakou Vocational and technical ecation center
if local people look at it, it's not good
but some outsiders think it's good
mostly rural people and outsiders