Can Yingtai btc250 reach 9600kf
Publish: 2021-03-29 19:52:04
1. M. 2. The SSD of the PCI channel needs to occupy the PCI channel, and the tb250-btc of the six cards also occupies multiple PCI channels. In this way, once the PCI SSD is inserted, the lack of the PCI channel of the CPU will cause hardware conflicts, which will lead to the failure of some graphics cards. Moreover, the mining machine does not have high requirements on the hard disk. Therefore, the mining machine had better not use the m.2 SSD of the PCI
2. It's just a hard disk. You can use it if you want. What's not recommended
3. Win10 professional edition, this hardware does not support win7!
4. B250 itself supports the M2 interface. Although adding m2 to the feeder board is unnecessary, you can transfer the PCI X4 channel from m2 to the graphics card. Mining only relies on GPU general-purpose computing, and has low performance requirements for hard disk and CPU
however, to play mining, it is recommended to buy a more efficient ant miner instead of a graphics card. The graphics card is only a general-purpose calculation, not a specific one. The ant miner has higher efficiency and lower power consumption.
however, to play mining, it is recommended to buy a more efficient ant miner instead of a graphics card. The graphics card is only a general-purpose calculation, not a specific one. The ant miner has higher efficiency and lower power consumption.
5.
this is a motherboard launched by Yingtai for the mining market. Its main advantage is that it has multiple PCI-E slots and can connect up to six graphics cards at the same time. If it is for ordinary household use, this motherboard has little advantage
if you like Yingtai motherboard, you can take a look at b250gt3, which is compatible with 6-9 generations of processors, and the configuration is much more reasonable
6. The motherboard adopts lga1151 pin and supports the sixth or seventh generation of lga1151 interface processor.
7.
There are airport buses and airport transfers
8. Take the bus to KL Sentral at the bus stop on the left side of the airport. The fare is RM10. It is open from 3 am to 12 midnight
9. Local tyrant, do you still need to answer? 300 RMB is enough
it's better to take the fast track for RM55. There are two, one price
the fastest and most expensive way is direct transportation, which takes one hour from the airport (T1 or T2) to the tourist center in the city center
the bus is cheaper. It's enough to drive 60 minutes faster, but it's usually promised to be 90 minutes.
it's better to take the fast track for RM55. There are two, one price
the fastest and most expensive way is direct transportation, which takes one hour from the airport (T1 or T2) to the tourist center in the city center
the bus is cheaper. It's enough to drive 60 minutes faster, but it's usually promised to be 90 minutes.
Hot content